Gould Engineering and Machining / VermontCNC products in action

[vermontcnc]

I wanted to start a thread for anyone that was kind enough to share their pics of products purchased from us. There are a bunch of our extended mag release pics floating around so I though it would be a good idea to have a thread just for pictures. Feel free to post up anything that uses one of our products 

[40below]

A Great extended Magazine release for SKS's, by Gould Engineering and Machining.

[juaneye]

The Tapco Mag Coupler/on Promags = perfect fit

other side

standing up

on the job plastic furniture

and with original


I might add also that both of these rifles have had bolt drop work done by VermontCNC too.

[juaneye]

A Great extended Magazine release for SKS's, by Gould Engineering and Machining.

Mr. 40below this is one of the best looking rifles I have ever seen, you have done an outstanding job with this, if it were mine I don't think I  would be able to fire it!!

[40below]

juaneye its funny You say You wouldn't be able to shoot the Zombie. I haven't "FIRED" it Yet.

[juaneye]

juaneye its funny You say You wouldn't be able to shoot the Zombie. I haven't "FIRED" it Yet.

 

I understand as I have a Colt Officers model that is so pretty (in my opinion anyway) I have only carried it 2-3 times in the 10 years I have owned it, bet is only has a few hundred rounds total run through it.  Some moron scratched it putting the retaining pin in after cleaning it one time, other then that she is pretty nice...I bet you could never guess who the moron was that scratched it.   

[1MOA]

The new extended mag release is just right. The pull is smooth and it is just the right length. This new S.S. release is now causing me to have to polish my old S.S. Trigger! 
Thanks for making these parts a permanent item in your inventory...may need a few more!