Retail And Business > The Marcus Magazine Adapter

Re: Videos: 1st 10May2010, 2nd 13May2010, 3rd 15May2010

<< < (3/3)

1mlt:
No problem, keep up the selling ... Marcus

Shinmen Takezo:
Here is a good read for you, Shinmen Takezo.

Thanks for the link.

And to Marcus... I just got my adaptor in the mail today.
It is wider than expected, more than the thickness of the tapco-duckbill.
So I am going to put it in the mill tomorrow and shave off a tad on each side.

I (like I told you) am installing it in a Russian fiberglass jungle stock.
I do not know if, or if I am not going to use the pin provided yet.
It may not be long enough or I may--don't know yet.
Is this a hardened steel pin? --or a cold (soft) steel pin?

Also this did not come with any layout instructions for the pin, or layout guide for cutting the duckbill off the mags.
Is this posted somewhere? Or do I have to wing this part?

I am thinking of making a router jig to make all the mags uniform when cut (and knock them out like tasty breads).
But I have to make a master to work off of first.

ST

1mlt:
The install instructions are at the website, as well, the mag mod instructions. Go there www.thesksmagadapter.com and print them. Or send your email address to me at 1mlt@sbcglobal.net and I'll email them back to you. The pin is hardened, but you can cut it with a Dremel cutoff wheel. Marcus

martin08:
Welcome to the show, Antibabylon.

There's a whole 'nother big world out there on the SKS Boards too, hope to see you out there!

Thanks for the videos, too.  And for those of you who don't have a band saw, I use a fine toothed Mitre saw and a dremel to smooth.

Navigation

[0] Message Index

[*] Previous page