I need a little help please

[1mlt]

We are back in the "drawing room". Can't share what we are doing, but, it is "adapter" related. If you gentlemen will help us out, we need a favor or 2. We have measured the width of the locking tab on the rear site. The one that holds the front of the factory 10 round mag in place. No 2 measured the same. Will you guys measure some of yours and post up here. We need to get a "representative range" that is realistic across the board? Thanks guys.
Marcus

[Rocketvapor]

Tab on a early Russian, and Sino-Soviet, and a Chi-Com
10.92mm to 10.95mm
Corresponding gap in several mags
11.05mm tightest to 11.30mm loosest. 

[1mlt]

Tab on a early Russian, and Sino-Soviet, and a Chi-Com
10.92mm to 10.95mm
Corresponding gap in several mags
11.05mm tightest to 11.30mm loosest. 

Thanks TV. That's a good start.

[Toad]

I didn't stay at a Holiday Inn last night.  Can you post a pic of the part you need a measurement on?

[Rocketvapor]

 "Width of the locking tab (lug under rear site) on the rear site. The one that holds the front of the factory 10 round mag in place"

Will not work with GLOCK magazines

Note that pictures will appear to be upside down unless you turn your phone.

[1mlt]

"Width of the locking tab (lug under rear site) on the rear site. The one that holds the front of the factory 10 round mag in place"

Will not work with GLOCK magazines

Note that pictures will appear to be upside down unless you turn your phone.

Thx RV.